Carbide tile drill set Ø 6, 8 and 10 mm
SKU 9096451
Carbide tile drill set Ø 6, 8 and 10 mm, 1 SOR
Application areas:
For wall and floor tiles up to scratch hardness 9 as well as limited glass and porcelain
Hints:
Maximum speed 200 rpm. Make sure there is sufficient contact pressure. No cooling required
Processing instructions:
Only drill rotating, switch off the impact mechanism!
Characteristics:
Diamond ground carbide plate. Scraping working method for chip-free drilling. Also enables drilling close to edges. Long service life
Innovative centering point. Safe drilling even on smooth surfaces. Virtually no slipping possible
Smooth, cylindrical shaft. Reduced friction and heat. Protects the borehole. Can be used in any commercially available drill
Application areas:
For wall and floor tiles up to scratch hardness 9 as well as limited glass and porcelain
Hints:
Maximum speed 200 rpm. Make sure there is sufficient contact pressure. No cooling required
Processing instructions:
Only drill rotating, switch off the impact mechanism!
Characteristics:
Diamond ground carbide plate. Scraping working method for chip-free drilling. Also enables drilling close to edges. Long service life
Innovative centering point. Safe drilling even on smooth surfaces. Virtually no slipping possible
Smooth, cylindrical shaft. Reduced friction and heat. Protects the borehole. Can be used in any commercially available drill