Insulating dowel ID 50 PZ3, 50 ST

Main features short:
Durable and safe
Replaces complex substructures
Made of high-quality and impact-resistant polyethylene

Hints:
To prevent water from entering, seal the edge of the dowel with sealant!
The length of the isod anchor must not be cut!
Further information at www.bti.de/duebelauszugstrie and. www.bti.de/duebelundankertechnik
You can access the calculation software at www.bti.de/duebelrechner

Processing instructions:
Screw in ID 50/ID 50 PZ3 with a Phillips screwdriver PZ 3. For plastered rigid foam panels (e.g. insulated house walls), drill out the plaster to the maximum dowel diameter before installing the isodwel. The holding power of the isod anchor depends on the quality of the rigid foam panels used. For materials with greater density (e.g. Styrodur), the values given here increase accordingly. A prerequisite for optimal holding values is also the professional installation of the insulating material, full-surface, tight and flat bonding of the insulating panels or glueing the insulating panels with staggered joints. Maximum breaking load (does not include a safety factor) of Styrofoam PS 20:. ID 50/PZ3: 173 N

Characteristics:
Made of high-quality and impact-resistant polyethylene. Ageing, weather and temperature resistant
Replaces complex substructures. Is screwed directly into the rigid foam board without pre-drilling
Durable and safe. Material displacement and compression ensure secure anchoring in the subsurface

Language

Language

insulation fixing

Filters

Language

Language

Compare products