Diamond drill bit ½” Ø 12 x 200 mm
SKU 9002136
Original price
€103,96
-
Original price
€103,96
Original price
Logge dich ein, um Preise zu sehen
€103,96
-
Logge dich ein, um Preise zu sehen
Current price
Logge dich ein, um Preise zu sehen
Diamond drill bit ½” Ø 12 x 200 mm, 1 piece
Main features short:
Combination shaft enables the optional use of R 1/2" or 1.1/4" UNC diamond core bits without modification
Starting current limitation
Integrated multifunctional electronics
Application areas:
Wet drilling:. Reinforced concrete, concrete without reinforcement, high-density sand-lime brick, hard clinker (soft sand-lime brick, aerated concrete, brick, Poroton, soft clinker)
Processing instructions:
To make it easier to remove the drill bits from the machine, you should always use a brass ring (accessory) that is inserted between the machine and the drill bit.
Characteristics:
Good service life thanks to 7 mm segment height
Good protection against segment loss thanks to a special soldering process
Ring-shaped block segment with Ø 10 – 42 mm. For dowel drilling (small tolerances)
Roof-shaped individual segments with Ø 51 – 132 mm. Easy centering and quick drilling. Higher feed over the entire service life (saving working time). Lower contact pressure required (protects user and machine)
Main features short:
Combination shaft enables the optional use of R 1/2" or 1.1/4" UNC diamond core bits without modification
Starting current limitation
Integrated multifunctional electronics
Application areas:
Wet drilling:. Reinforced concrete, concrete without reinforcement, high-density sand-lime brick, hard clinker (soft sand-lime brick, aerated concrete, brick, Poroton, soft clinker)
Processing instructions:
To make it easier to remove the drill bits from the machine, you should always use a brass ring (accessory) that is inserted between the machine and the drill bit.
Characteristics:
Good service life thanks to 7 mm segment height
Good protection against segment loss thanks to a special soldering process
Ring-shaped block segment with Ø 10 – 42 mm. For dowel drilling (small tolerances)
Roof-shaped individual segments with Ø 51 – 132 mm. Easy centering and quick drilling. Higher feed over the entire service life (saving working time). Lower contact pressure required (protects user and machine)