Hammer drill Triathlon x plus SDS-max 37 x 450 / 570 mm

Hammer drill Triathlon x plus SDS-max 37 x 450 / 570 mm, 1 ST

Main features short:
3 cutting edges ensure circular and precise drilling

Application areas:
For drilling in (reinforced) concrete, masonry and natural stone

Hints:
When using long drill bits, it is advisable to start the hole with a short drill bit of the same diameter
More information at www.bti.de/triathlonxplus

Processing instructions:
Reinforcement hit: Continue working with reduced pressure. The cutting edge geometry of a rock drill is only suitable for drilling reinforcement to a very limited extent.

Characteristics:
3-edged carbide geometry. Exactly circular bores, important for dowel fastenings and low-vibration operation for reduced stress on the user
Short transition from carbide tip to drill helix. Very good drilling dust removal
3 steep, large-volume turns. Optimum removal of drilling dust. Counteracts heat generation in the drill hole, reduces frictional resistance and increases the service life of the drill
150° point angle with center point. Ensures improved and faster drilling
Wear mark on the carbide. Results in dimensionally accurate drill holes
Shot peened surface of the drill body. Reduces wear on the drill flute
One-piece, brazed carbide drill head with diameters of 16 mm - 28 mm. Provides a very good and direct transfer of energy from the rotary hammer to the drill bit
4-piece brazed carbide drill head with diameters of 30 mm - 42 mm. Stresses that occur when drilling can be better absorbed and the load distributed better